Features:1. On-board DIP switch, you can easily adjust the drive segments
2. Terminal power connector for easy connection drive power
3. Compatible with 12 / 24V drive scheme
4. Suitable for 42 stepper motor drive, 3D printers and DIYSpecifications:Size: 42 x 42 x 15mm
Pitch: 1400 x 1400m..
A4988 is a complete microstepping motor driver with built-in translator for easy operation. This product is available in full, half, 1/4, 1/8 and 1/16 step modes operate bipolar stepper motors, output drive capacity of up to 35 V and ± 2 A. A4988 includes a fixed off-time current regul..
Description:Fully assembled & tested, no soldering required
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost
The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replace..
The module has an interface pinout is almost the same with A4988 stepper motor drive carrier, so that it can be used as a higher performance in a pull-down menu the plates replaced in many applications.
DRV8825 features an adjustable current limit, overcurrent and overtemperature pro..
Perfect match with: (package does includes)
Motor driver with 4.5A: MKS TB6600
3D printer motherboard: MKS-GenFeature:
In current 42 motor-driver of 3D printer on the market is that the direct primary IC connect to motor driver IC, the current consumed by each interface will not exceed 2MA.
The MKS ..
It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of us..
Features:1. 9V-40V DC power supply
2. H-bridge bipolar constant phase flow driver
3. The maximum output current is 4.0A (eight optional)
4. Up to 32 segments of six kinds of sub-modes available
5. The input signal high-speed photoelectric isolatio
6. Standard common anode single pulse interface
- CNC Shield BoardVersion: 3.0
Size(L*W*H): 68 x 53 x 18 mm
Voltage: DC 12~36 V (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)Features:
1. Uses removable A4988 or DRV8825 compatible stepper drivers.
2. The ex..
Can be used in Ramps1.4 and MKS Base, MKS Gen, MKS Mini and a series of motherboards.Features:
1. 2.8 inch full color touch screen, support U disk and SD card.
2. Reserved Wifi interface, adds the Wifi interface can support Wifi (package does not includes the wifi module).
3. Provide continuous soft..
Features:1. Power module for controlling 3D printer heated bed
2. Handle high current but without being heat at the same time
3. Powerful MOSFET HA210NO6
4. Allow PID control of the heated bed (DC-DC Relays usually do not allow this)
5. Safe for prolonged times without active cooling.
6. Can wi..
Descriptions:1. Arduino CNC Shield V3 3D Printer Expansion Board
This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
It is a total of four slots, can drive four A4988 stepper motor.
Each road stepper motors only need two IO ports. In other words, six IO..
Features:-Adjusting the laser power
-Low Light Function
-Support for High Power Laser
-Become the DIY engraving machine first choice,support for adjusting the laser power, weak light, all-optical coupling isolation, anti-interference, high power laser, support Python master soft..